Struct esp32s3_hal::pac::spi1::ctrl1::W

pub struct W(_);

Register CTRL1 writer

Implementations

impl W

pub fn clk_mode(
    &mut self
) -> FieldWriterRaw<'_, u32, CTRL1_SPEC, u8, u8, Unsafe, 2, 0>

Bits 0:1 - SPI Bus clock (SPI_CLK) mode bits. 0: SPI Bus clock (SPI_CLK) is off when CS inactive 1: SPI_CLK is delayed one cycle after SPI_CS inactive 2: SPI_CLK is delayed two cycles after SPI_CS inactive 3: SPI_CLK is always on.

pub fn cs_hold_dly_res(
    &mut self
) -> FieldWriterRaw<'_, u32, CTRL1_SPEC, u16, u16, Unsafe, 10, 2>

Bits 2:11 - After RES/DP/HPM/PES/PER command is sent, SPI1 may waits (SPI_MEM_CS_HOLD_DELAY_RES[9:0] * 4 or * 256) SPI_CLK cycles.

pub unsafe fn bits(&mut self, bits: u32) -> &mut W

Writes raw bits to the register.

Methods from Deref<Target = W<CTRL1_SPEC>>

pub unsafe fn bits(&mut self, bits: <REG as RegisterSpec>::Ux) -> &mut W<REG>

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<CTRL1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<W as Deref>::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut <W as Deref>::Target

Mutably dereferences the value.

impl From<W<CTRL1_SPEC>> for W

fn from(writer: W<CTRL1_SPEC>) -> W

Converts to this type from the input type.