Struct esp32s3_hal::pac::spi0::ctrl::R

pub struct R(_);

Register CTRL reader

Implementations

impl R

pub fn fdummy_out(&self) -> BitReaderRaw<bool>

Bit 3 - In the DUMMY phase the signal level of SPI bus is output by the SPI0 controller.

pub fn fdout_oct(&self) -> BitReaderRaw<bool>

Bit 4 - Set this bit to enable 8-bit-mode(8-bm) in DOUT phase.

pub fn fdin_oct(&self) -> BitReaderRaw<bool>

Bit 5 - Set this bit to enable 8-bit-mode(8-bm) in DIN phase.

pub fn faddr_oct(&self) -> BitReaderRaw<bool>

Bit 6 - Set this bit to enable 8-bit-mode(8-bm) in ADDR phase.

pub fn fcmd_dual(&self) -> BitReaderRaw<bool>

Bit 7 - Set this bit to enable 2-bit-mode(2-bm) in CMD phase.

pub fn fcmd_quad(&self) -> BitReaderRaw<bool>

Bit 8 - Set this bit to enable 4-bit-mode(4-bm) in CMD phase.

pub fn fcmd_oct(&self) -> BitReaderRaw<bool>

Bit 9 - Set this bit to enable 8-bit-mode(8-bm) in CMD phase.

pub fn fastrd_mode(&self) -> BitReaderRaw<bool>

Bit 13 - This bit should be set when SPI_MEM_FREAD_QIO, SPI_MEM_FREAD_DIO, SPI_MEM_FREAD_QUAD or SPI_MEM_FREAD_DUAL is set.

pub fn fread_dual(&self) -> BitReaderRaw<bool>

Bit 14 - In hardware 0x3B read operation, DIN phase apply 2 signals. 1: enable 0: disable.

pub fn q_pol(&self) -> BitReaderRaw<bool>

Bit 18 - The bit is used to set MISO line polarity, 1: high 0, low

pub fn d_pol(&self) -> BitReaderRaw<bool>

Bit 19 - The bit is used to set MOSI line polarity, 1: high 0, low

pub fn fread_quad(&self) -> BitReaderRaw<bool>

Bit 20 - In hardware 0x6B read operation, DIN phase apply 4 signals(4-bit-mode). 1: enable 0: disable.

pub fn wp(&self) -> BitReaderRaw<bool>

Bit 21 - Write protect signal output when SPI is idle. 1: output high, 0: output low.

pub fn fread_dio(&self) -> BitReaderRaw<bool>

Bit 23 - In hardware 0xBB read operation, ADDR phase and DIN phase apply 2 signals(2-bit-mode). 1: enable 0: disable.

pub fn fread_qio(&self) -> BitReaderRaw<bool>

Bit 24 - In hardware 0xEB read operation, ADDR phase and DIN phase apply 4 signals(4-bit-mode). 1: enable 0: disable.

Methods from Deref<Target = R<CTRL_SPEC>>

pub fn bits(&self) -> <REG as RegisterSpec>::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CTRL_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<R as Deref>::Target

Dereferences the value.

impl From<R<CTRL_SPEC>> for R

fn from(reader: R<CTRL_SPEC>) -> R

Converts to this type from the input type.