Struct esp32s3_hal::pac::usb_device::ep1_conf::R

pub struct R(_);

Register EP1_CONF reader

Implementations

impl R

pub fn serial_in_ep_data_free(&self) -> BitReaderRaw<bool>

Bit 1 - 1’b1: Indicate UART Tx FIFO is not full and can write data into in. After writing USB_DEVICE_WR_DONE, this bit would be 0 until data in UART Tx FIFO is read by USB Host.

pub fn serial_out_ep_data_avail(&self) -> BitReaderRaw<bool>

Bit 2 - 1’b1: Indicate there is data in UART Rx FIFO.

Methods from Deref<Target = R<EP1_CONF_SPEC>>

pub fn bits(&self) -> <REG as RegisterSpec>::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<EP1_CONF_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<R as Deref>::Target

Dereferences the value.

impl From<R<EP1_CONF_SPEC>> for R

fn from(reader: R<EP1_CONF_SPEC>) -> R

Converts to this type from the input type.