Struct esp32s3_hal::pac::sens::sar_tsens_ctrl::W

pub struct W(_);

Register SAR_TSENS_CTRL writer

Implementations

impl W

pub fn sar_tsens_int_en(
    &mut self
) -> BitWriterRaw<'_, u32, SAR_TSENS_CTRL_SPEC, bool, BitM, 12>

Bit 12 - enable temperature sensor to send out interrupt

pub fn sar_tsens_in_inv(
    &mut self
) -> BitWriterRaw<'_, u32, SAR_TSENS_CTRL_SPEC, bool, BitM, 13>

Bit 13 - invert temperature sensor data

pub fn sar_tsens_clk_div(
    &mut self
) -> FieldWriterRaw<'_, u32, SAR_TSENS_CTRL_SPEC, u8, u8, Unsafe, 8, 14>

Bits 14:21 - temperature sensor clock divider

pub fn sar_tsens_power_up(
    &mut self
) -> BitWriterRaw<'_, u32, SAR_TSENS_CTRL_SPEC, bool, BitM, 22>

Bit 22 - temperature sensor power up

pub fn sar_tsens_power_up_force(
    &mut self
) -> BitWriterRaw<'_, u32, SAR_TSENS_CTRL_SPEC, bool, BitM, 23>

Bit 23 - 1: dump out & power up controlled by SW 0: by FSM

pub fn sar_tsens_dump_out(
    &mut self
) -> BitWriterRaw<'_, u32, SAR_TSENS_CTRL_SPEC, bool, BitM, 24>

Bit 24 - temperature sensor dump out only active when reg_tsens_power_up_force = 1

pub unsafe fn bits(&mut self, bits: u32) -> &mut W

Writes raw bits to the register.

Methods from Deref<Target = W<SAR_TSENS_CTRL_SPEC>>

pub unsafe fn bits(&mut self, bits: <REG as RegisterSpec>::Ux) -> &mut W<REG>

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<SAR_TSENS_CTRL_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<W as Deref>::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut <W as Deref>::Target

Mutably dereferences the value.

impl From<W<SAR_TSENS_CTRL_SPEC>> for W

fn from(writer: W<SAR_TSENS_CTRL_SPEC>) -> W

Converts to this type from the input type.