Struct esp32s3_hal::pac::rtc_i2c::ctrl::R

pub struct R(_);

Register CTRL reader

Implementations

impl R

pub fn sda_force_out(&self) -> BitReaderRaw<bool>

Bit 0 - 1=push pull,0=open drain

pub fn scl_force_out(&self) -> BitReaderRaw<bool>

Bit 1 - 1=push pull,0=open drain

pub fn ms_mode(&self) -> BitReaderRaw<bool>

Bit 2 - 1=master,0=slave

pub fn trans_start(&self) -> BitReaderRaw<bool>

Bit 3 - force start

pub fn tx_lsb_first(&self) -> BitReaderRaw<bool>

Bit 4 - transit lsb first

pub fn rx_lsb_first(&self) -> BitReaderRaw<bool>

Bit 5 - receive lsb first

pub fn i2c_ctrl_clk_gate_en(&self) -> BitReaderRaw<bool>

Bit 29 - configure i2c ctrl clk enable

pub fn i2c_reset(&self) -> BitReaderRaw<bool>

Bit 30 - rtc i2c sw reset

pub fn i2cclk_en(&self) -> BitReaderRaw<bool>

Bit 31 - rtc i2c reg clk gating

Methods from Deref<Target = R<CTRL_SPEC>>

pub fn bits(&self) -> <REG as RegisterSpec>::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CTRL_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<R as Deref>::Target

Dereferences the value.

impl From<R<CTRL_SPEC>> for R

fn from(reader: R<CTRL_SPEC>) -> R

Converts to this type from the input type.