Struct esp32s3_hal::pac::dma::out_conf0_ch::R

pub struct R(_);

Register OUT_CONF0_CH%s reader

Implementations

impl R

pub fn out_rst(&self) -> BitReaderRaw<bool>

Bit 0 - This bit is used to reset DMA channel 0 Tx FSM and Tx FIFO pointer.

pub fn out_loop_test(&self) -> BitReaderRaw<bool>

Bit 1 - reserved

pub fn out_auto_wrback(&self) -> BitReaderRaw<bool>

Bit 2 - Set this bit to enable automatic outlink-writeback when all the data in tx buffer has been transmitted.

pub fn out_eof_mode(&self) -> BitReaderRaw<bool>

Bit 3 - EOF flag generation mode when transmitting data. 1: EOF flag for Tx channel 0 is generated when data need to transmit has been popped from FIFO in DMA

pub fn outdscr_burst_en(&self) -> BitReaderRaw<bool>

Bit 4 - Set this bit to 1 to enable INCR burst transfer for Tx channel 0 reading link descriptor when accessing internal SRAM.

pub fn out_data_burst_en(&self) -> BitReaderRaw<bool>

Bit 5 - Set this bit to 1 to enable INCR burst transfer for Tx channel 0 transmitting data when accessing internal SRAM.

Methods from Deref<Target = R<OUT_CONF0_CH_SPEC>>

pub fn bits(&self) -> <REG as RegisterSpec>::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<OUT_CONF0_CH_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<R as Deref>::Target

Dereferences the value.

impl From<R<OUT_CONF0_CH_SPEC>> for R

fn from(reader: R<OUT_CONF0_CH_SPEC>) -> R

Converts to this type from the input type.