Struct esp32s2::uart0::flow_conf::W

pub struct W(_);

Register FLOW_CONF writer

Implementations

impl W

pub fn sw_flow_con_en(&mut self) -> SW_FLOW_CON_EN_W<'_, 0>

Bit 0 - Set this bit to enable software flow control. When UART receives flow control characters XON or XOFF, which can be configured by UART_XON_CHAR or UART_XOFF_CHAR respectively, UART_SW_XON_INT or UART_SW_XOFF_INT interrupts can be triggered if enabled.

pub fn xonoff_del(&mut self) -> XONOFF_DEL_W<'_, 1>

Bit 1 - Set this bit to remove flow control characters from the received data.

pub fn force_xon(&mut self) -> FORCE_XON_W<'_, 2>

Bit 2 - Set this bit to force the transmitter to send data.

pub fn force_xoff(&mut self) -> FORCE_XOFF_W<'_, 3>

Bit 3 - Set this bit to stop the transmitter from sending data.

pub fn send_xon(&mut self) -> SEND_XON_W<'_, 4>

Bit 4 - Set this bit to send an XON character. This bit is cleared by hardware automatically.

pub fn send_xoff(&mut self) -> SEND_XOFF_W<'_, 5>

Bit 5 - Set this bit to send an XOFF character. This bit is cleared by hardware automatically.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<FLOW_CONF_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<FLOW_CONF_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<FLOW_CONF_SPEC>> for W

fn from(writer: W<FLOW_CONF_SPEC>) -> Self

Converts to this type from the input type.