Struct esp32s2::sens::sar_meas1_ctrl2::R

pub struct R(_);

Register SAR_MEAS1_CTRL2 reader

Implementations

impl R

pub fn meas1_data_sar(&self) -> MEAS1_DATA_SAR_R

Bits 0:15 - SAR ADC1 data

pub fn meas1_done_sar(&self) -> MEAS1_DONE_SAR_R

Bit 16 - Indicate SAR ADC1 conversion is done.

pub fn meas1_start_sar(&self) -> MEAS1_START_SAR_R

Bit 17 - SAR ADC1 controller (in RTC) starts conversion, active only when SENS_MEAS1_START_FORCE = 1.

pub fn meas1_start_force(&self) -> MEAS1_START_FORCE_R

Bit 18 - 1: SAR ADC1 controller (in RTC) is started by software. 0: SAR ADC1 controller is started by ULP coprocessor.

pub fn sar1_en_pad(&self) -> SAR1_EN_PAD_R

Bits 19:30 - SAR ADC1 pad enable bitmap, active only when SENS_SAR1_EN_PAD_FORCE = 1.

pub fn sar1_en_pad_force(&self) -> SAR1_EN_PAD_FORCE_R

Bit 31 - 1: SAR ADC1 pad enable bitmap is controlled by software. 0: SAR ADC1 pad enable bitmap is controlled by ULP coprocessor.

Methods from Deref<Target = R<SAR_MEAS1_CTRL2_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<SAR_MEAS1_CTRL2_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<SAR_MEAS1_CTRL2_SPEC>> for R

fn from(reader: R<SAR_MEAS1_CTRL2_SPEC>) -> Self

Converts to this type from the input type.