Struct esp32s2::uart0::rs485_conf::R

pub struct R(_);

Register RS485_CONF reader

Implementations

impl R

pub fn rs485_en(&self) -> RS485_EN_R

Bit 0 - Set this bit to choose RS485 mode.

pub fn dl0_en(&self) -> DL0_EN_R

Bit 1 - Set this bit to delay the stop bit by 1 bit.

pub fn dl1_en(&self) -> DL1_EN_R

Bit 2 - Set this bit to delay the stop bit by 1 bit.

pub fn rs485tx_rx_en(&self) -> RS485TX_RX_EN_R

Bit 3 - Set this bit to enable the receiver could receive data when the transmitter is transmitting data in RS485 mode.

pub fn rs485rxby_tx_en(&self) -> RS485RXBY_TX_EN_R

Bit 4 - 1: enable RS485 transmitter to send data when RS485 receiver line is busy. 0: RS485 transmitter should not send data when its receiver is busy.

pub fn rs485_rx_dly_num(&self) -> RS485_RX_DLY_NUM_R

Bit 5 - This register is used to delay the receiver’s internal data signal.

pub fn rs485_tx_dly_num(&self) -> RS485_TX_DLY_NUM_R

Bits 6:9 - This register is used to delay the transmitter’s internal data signal.

Methods from Deref<Target = R<RS485_CONF_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<RS485_CONF_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<RS485_CONF_SPEC>> for R

fn from(reader: R<RS485_CONF_SPEC>) -> Self

Converts to this type from the input type.