Struct esp32s2::spi0::slv_rd_byte::R

pub struct R(_);

Register SLV_RD_BYTE reader

Implementations

impl R

pub fn slv_data_bytelen(&self) -> SLV_DATA_BYTELEN_R

Bits 0:19 - The full-duplex or half-duplex data byte length of the last SPI transfer in slave mode. In half-duplex mode, this value is controlled by bits [23:20].

pub fn slv_rddma_bytelen_en(&self) -> SLV_RDDMA_BYTELEN_EN_R

Bit 20 - 1: SPI_SLV_DATA_BYTELEN stores data byte length of master-read-slave data length in DMA controlled mode(Rd_DMA). 0: others

pub fn slv_wrdma_bytelen_en(&self) -> SLV_WRDMA_BYTELEN_EN_R

Bit 21 - 1: SPI_SLV_DATA_BYTELEN stores data byte length of master-write-to-slave data length in DMA controlled mode(Wr_DMA). 0: others

pub fn slv_rdbuf_bytelen_en(&self) -> SLV_RDBUF_BYTELEN_EN_R

Bit 22 - 1: SPI_SLV_DATA_BYTELEN stores data byte length of master-read-slave data length in CPU controlled mode(Rd_BUF). 0: others

pub fn slv_wrbuf_bytelen_en(&self) -> SLV_WRBUF_BYTELEN_EN_R

Bit 23 - 1: SPI_SLV_DATA_BYTELEN stores data byte length of master-write-to-slave data length in CPU controlled mode(Wr_BUF). 0: others

pub fn dma_seg_magic_value(&self) -> DMA_SEG_MAGIC_VALUE_R

Bits 24:27 - The magic value of BM table in master DMA seg-trans.

pub fn slv_rd_dma_done(&self) -> SLV_RD_DMA_DONE_R

Bit 30 - The interrupt raw bit for the completion of Rd-DMA operation in the slave mode. Can not be changed by CONF_buf.

pub fn usr_conf(&self) -> USR_CONF_R

Bit 31 - 1: Enable the DMA CONF phase of current seg-trans operation, which means seg-trans will start. 0: This is not seg-trans mode.

Methods from Deref<Target = R<SLV_RD_BYTE_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<SLV_RD_BYTE_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<SLV_RD_BYTE_SPEC>> for R

fn from(reader: R<SLV_RD_BYTE_SPEC>) -> Self

Converts to this type from the input type.