Struct esp32s2::uhci0::escape_conf::R

pub struct R(_);

Register ESCAPE_CONF reader

Implementations

impl R

pub fn tx_c0_esc_en(&self) -> TX_C0_ESC_EN_R

Bit 0 - Set this bit to decode character 0xC0 when DMA receives data.

pub fn tx_db_esc_en(&self) -> TX_DB_ESC_EN_R

Bit 1 - Set this bit to decode character 0xDB when DMA receives data.

pub fn tx_11_esc_en(&self) -> TX_11_ESC_EN_R

Bit 2 - Set this bit to decode flow control character 0x11 when DMA receives data.

pub fn tx_13_esc_en(&self) -> TX_13_ESC_EN_R

Bit 3 - Set this bit to decode flow control character 0x13 when DMA receives data.

pub fn rx_c0_esc_en(&self) -> RX_C0_ESC_EN_R

Bit 4 - Set this bit to replace 0xC0 by special characters when DMA sends data.

pub fn rx_db_esc_en(&self) -> RX_DB_ESC_EN_R

Bit 5 - Set this bit to replace 0xDB by special characters when DMA sends data.

pub fn rx_11_esc_en(&self) -> RX_11_ESC_EN_R

Bit 6 - Set this bit to replace flow control character 0x11 by special characters when DMA sends data.

pub fn rx_13_esc_en(&self) -> RX_13_ESC_EN_R

Bit 7 - Set this bit to replace flow control character 0x13 by special characters when DMA sends data.

Methods from Deref<Target = R<ESCAPE_CONF_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<ESCAPE_CONF_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<ESCAPE_CONF_SPEC>> for R

fn from(reader: R<ESCAPE_CONF_SPEC>) -> Self

Converts to this type from the input type.