Struct esp32s2::io_mux::gpio3::W

pub struct W(_);

Register GPIO3 writer

Implementations

impl W

pub fn mcu_oe(&mut self) -> MCU_OE_W<'_, 0>

Bit 0 - Output enable of the pin in sleep mode. 1: Output enabled. 0: Output disabled.

pub fn slp_sel(&mut self) -> SLP_SEL_W<'_, 1>

Bit 1 - Sleep mode selection of this pin. Set to 1 to put the pin in sleep mode.

pub fn mcu_wpd(&mut self) -> MCU_WPD_W<'_, 2>

Bit 2 - Pull-down enable of the pin during sleep mode. 1: Internal pull-down enabled. 0: internal pull-down disabled.

pub fn mcu_wpu(&mut self) -> MCU_WPU_W<'_, 3>

Bit 3 - Pull-up enable of the pin during sleep mode. 1: Internal pull-up enabled. 0: Internal pull-up disabled.

pub fn mcu_ie(&mut self) -> MCU_IE_W<'_, 4>

Bit 4 - Input enable of the pin during sleep mode. 1: Input enabled. 0: Input disabled.

pub fn fun_wpd(&mut self) -> FUN_WPD_W<'_, 7>

Bit 7 - Pull-down enable of the pin. 1: Internal pull-down enabled. 0: internal pull-down disabled.

pub fn fun_wpu(&mut self) -> FUN_WPU_W<'_, 8>

Bit 8 - Pull-up enable of the pin. 1: Internal pull-up enabled. 0: Internal pull-up disabled.

pub fn fun_ie(&mut self) -> FUN_IE_W<'_, 9>

Bit 9 - Input enable of the pin. 1: Input enabled. 0: Input disabled.

pub fn fun_drv(&mut self) -> FUN_DRV_W<'_, 10>

Bits 10:11 - Select the drive strength of the pin. 0: ~5 mA. 1: ~10 mA. 2: ~20 mA. 3: ~40 mA.

pub fn mcu_sel(&mut self) -> MCU_SEL_W<'_, 12>

Bits 12:14 - Select IO MUX function for this signal. 0: Select Function 1. 1: Select Function 2, etc.

pub fn filter_en(&mut self) -> FILTER_EN_W<'_, 15>

Bit 15 - Enable filter for pin input signals. 1: Filter enabled. 2: Filter disabled.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<GPIO3_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<GPIO3_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<GPIO3_SPEC>> for W

fn from(writer: W<GPIO3_SPEC>) -> Self

Converts to this type from the input type.