Struct esp32s2::uart0::flow_conf::R

pub struct R(_);

Register FLOW_CONF reader

Implementations

impl R

pub fn sw_flow_con_en(&self) -> SW_FLOW_CON_EN_R

Bit 0 - Set this bit to enable software flow control. When UART receives flow control characters XON or XOFF, which can be configured by UART_XON_CHAR or UART_XOFF_CHAR respectively, UART_SW_XON_INT or UART_SW_XOFF_INT interrupts can be triggered if enabled.

pub fn xonoff_del(&self) -> XONOFF_DEL_R

Bit 1 - Set this bit to remove flow control characters from the received data.

pub fn force_xon(&self) -> FORCE_XON_R

Bit 2 - Set this bit to force the transmitter to send data.

pub fn force_xoff(&self) -> FORCE_XOFF_R

Bit 3 - Set this bit to stop the transmitter from sending data.

pub fn send_xon(&self) -> SEND_XON_R

Bit 4 - Set this bit to send an XON character. This bit is cleared by hardware automatically.

pub fn send_xoff(&self) -> SEND_XOFF_R

Bit 5 - Set this bit to send an XOFF character. This bit is cleared by hardware automatically.

Methods from Deref<Target = R<FLOW_CONF_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<FLOW_CONF_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<FLOW_CONF_SPEC>> for R

fn from(reader: R<FLOW_CONF_SPEC>) -> Self

Converts to this type from the input type.