Struct esp32s2::uhci0::dma_in_status::R

pub struct R(_);

Register DMA_IN_STATUS reader

Implementations

impl R

pub fn in_full(&self) -> IN_FULL_R

Bit 0 - Data-input FIFO full signal.

pub fn in_empty(&self) -> IN_EMPTY_R

Bit 1 - Data-input FIFO empty signal.

pub fn rx_err_cause(&self) -> RX_ERR_CAUSE_R

Bits 4:6 - This register indicates the error type when DMA has received a packet with error. 3’b001: Checksum error in the HCI packet; 3’b010: Sequence number error in the HCI packet; 3’b011: CRC bit error in the HCI packet; 3’b100: 0xC0 is found but the received HCI packet is not end; 3’b101: 0xC0 is not found when the HCI packet has been received; 3’b110: CRC check error.

Methods from Deref<Target = R<DMA_IN_STATUS_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<DMA_IN_STATUS_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<DMA_IN_STATUS_SPEC>> for R

fn from(reader: R<DMA_IN_STATUS_SPEC>) -> Self

Converts to this type from the input type.