Type Alias W 

pub type W = W<FIFO_CONF_SPEC>;

Register FIFO_CONF writer

Aliased Type

pub struct W { /* private fields */ }

Implementations

impl W

pub fn rxfifo_wm_thrhd(&mut self) -> RXFIFO_WM_THRHD_W<'_, FIFO_CONF_SPEC>

Bits 0:4 - Configures the water mark threshold of RXFIFO in nonfifo access mode. When reg_reg_fifo_prt_en is 1 and rx FIFO counter is bigger than reg_rxfifo_wm_thrhd[4:0], reg_rxfifo_wm_int_raw bit will be valid.

pub fn txfifo_wm_thrhd(&mut self) -> TXFIFO_WM_THRHD_W<'_, FIFO_CONF_SPEC>

Bits 5:9 - Configures the water mark threshold of TXFIFO in nonfifo access mode. When reg_reg_fifo_prt_en is 1 and tx FIFO counter is smaller than reg_txfifo_wm_thrhd[4:0], reg_txfifo_wm_int_raw bit will be valid.

pub fn nonfifo_en(&mut self) -> NONFIFO_EN_W<'_, FIFO_CONF_SPEC>

Bit 10 - Configures to enable APB nonfifo access.

pub fn fifo_addr_cfg_en(&mut self) -> FIFO_ADDR_CFG_EN_W<'_, FIFO_CONF_SPEC>

Bit 11 - Configures to enable double addressing mode. When this mode is enabled, the byte received after the I2C address byte represents the offset address in the I2C Slave RAM. 0: Disable 1: Enable

pub fn rx_fifo_rst(&mut self) -> RX_FIFO_RST_W<'_, FIFO_CONF_SPEC>

Bit 12 - Configures to reset RXFIFO. 0: No effect 1: Reset

pub fn tx_fifo_rst(&mut self) -> TX_FIFO_RST_W<'_, FIFO_CONF_SPEC>

Bit 13 - Configures to reset TXFIFO. 0: No effect 1: Reset

pub fn fifo_prt_en(&mut self) -> FIFO_PRT_EN_W<'_, FIFO_CONF_SPEC>

Bit 14 - Configures to enable FIFO pointer in non-fifo access mode. This bit controls the valid bits and the TX/RX FIFO overflow, underflow, full and empty interrupts. 0: No effect 1: Enable