Struct esp32h2::i2s0::rx_conf1::W

pub struct W(_);

Register RX_CONF1 writer

Implementations

impl W

pub fn rx_tdm_ws_width(&mut self) -> RX_TDM_WS_WIDTH_W<'_, 0>

Bits 0:8 - The width of rx_ws_out at idle level in TDM mode is (I2S_RX_TDM_WS_WIDTH[8:0] +1) * T_bck

pub fn rx_bits_mod(&mut self) -> RX_BITS_MOD_W<'_, 14>

Bits 14:18 - Set the bits to configure the valid data bit length of I2S receiver channel. 7: all the valid channel data is in 8-bit-mode. 15: all the valid channel data is in 16-bit-mode. 23: all the valid channel data is in 24-bit-mode. 31:all the valid channel data is in 32-bit-mode.

pub fn rx_half_sample_bits(&mut self) -> RX_HALF_SAMPLE_BITS_W<'_, 19>

Bits 19:26 - I2S Rx half sample bits -1.

pub fn rx_tdm_chan_bits(&mut self) -> RX_TDM_CHAN_BITS_W<'_, 27>

Bits 27:31 - The Rx bit number for each channel minus 1in TDM mode.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<RX_CONF1_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<RX_CONF1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<RX_CONF1_SPEC>> for W

fn from(writer: W<RX_CONF1_SPEC>) -> Self

Converts to this type from the input type.