Struct esp32h2::spi2::user1::R

pub struct R(_);

Register USER1 reader

Implementations

impl R

pub fn usr_dummy_cyclelen(&self) -> USR_DUMMY_CYCLELEN_R

Bits 0:7 - The length in spi_clk cycles of dummy phase. The register value shall be (cycle_num-1). Can be configured in CONF state.

pub fn mst_wfull_err_end_en(&self) -> MST_WFULL_ERR_END_EN_R

Bit 16 - 1: SPI transfer is ended when SPI RX AFIFO wfull error is valid in GP-SPI master FD/HD-mode. 0: SPI transfer is not ended when SPI RX AFIFO wfull error is valid in GP-SPI master FD/HD-mode.

pub fn cs_setup_time(&self) -> CS_SETUP_TIME_R

Bits 17:21 - (cycles+1) of prepare phase by spi clock this bits are combined with spi_cs_setup bit. Can be configured in CONF state.

pub fn cs_hold_time(&self) -> CS_HOLD_TIME_R

Bits 22:26 - delay cycles of cs pin by spi clock this bits are combined with spi_cs_hold bit. Can be configured in CONF state.

pub fn usr_addr_bitlen(&self) -> USR_ADDR_BITLEN_R

Bits 27:31 - The length in bits of address phase. The register value shall be (bit_num-1). Can be configured in CONF state.

Methods from Deref<Target = R<USER1_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<USER1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<USER1_SPEC>> for R

fn from(reader: R<USER1_SPEC>) -> Self

Converts to this type from the input type.