Struct esp32c6::rmt::ch_rx_conf1::R

pub struct R(_);

Register CH%s_RX_CONF1 reader

Implementations

impl R

pub fn rx_en(&self) -> RX_EN_R

Bit 0 - Set this bit to enable receiver to receive data on CHANNEL%s.

pub fn mem_owner(&self) -> MEM_OWNER_R

Bit 3 - This register marks the ownership of CHANNEL%s’s ram block. 1’h1: Receiver is using the ram. 1’h0: APB bus is using the ram.

pub fn rx_filter_en(&self) -> RX_FILTER_EN_R

Bit 4 - This is the receive filter’s enable bit for CHANNEL%s.

pub fn rx_filter_thres(&self) -> RX_FILTER_THRES_R

Bits 5:12 - Ignores the input pulse when its width is smaller than this register value in APB clock periods (in receive mode).

pub fn mem_rx_wrap_en(&self) -> MEM_RX_WRAP_EN_R

Bit 13 - This is the channel %s enable bit for wraparound mode: it will resume receiving at the start when the data to be received is more than its memory size.

Methods from Deref<Target = R<CH_RX_CONF1_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CH_RX_CONF1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<CH_RX_CONF1_SPEC>> for R

fn from(reader: R<CH_RX_CONF1_SPEC>) -> Self

Converts to this type from the input type.