Type Alias esp32c3::io_mux::gpio::W

pub type W = W<GPIO_SPEC>;

Register GPIO%s writer

Aliased Type

struct W { /* private fields */ }

Implementations

impl W

pub fn mcu_oe(&mut self) -> MCU_OE_W<'_, GPIO_SPEC>

Bit 0 - Output enable of the pad in sleep mode. 1: output enabled; 0: output disabled.

pub fn slp_sel(&mut self) -> SLP_SEL_W<'_, GPIO_SPEC>

Bit 1 - Sleep mode selection of this pad. Set to 1 to put the pad in pad mode.

pub fn mcu_wpd(&mut self) -> MCU_WPD_W<'_, GPIO_SPEC>

Bit 2 - Pull-down enable of the pad in sleep mode. 1: internal pull-down enabled; 0: internal pull-down disabled.

pub fn mcu_wpu(&mut self) -> MCU_WPU_W<'_, GPIO_SPEC>

Bit 3 - Pull-up enable of the pad during sleep mode. 1: internal pull-up enabled; 0: internal pull-up disabled.

pub fn mcu_ie(&mut self) -> MCU_IE_W<'_, GPIO_SPEC>

Bit 4 - Input enable of the pad during sleep mode. 1: input enabled; 0: input disabled.

pub fn fun_wpd(&mut self) -> FUN_WPD_W<'_, GPIO_SPEC>

Bit 7 - Pull-down enable of the pad. 1: internal pull-down enabled; 0: internal pull-down disabled.

pub fn fun_wpu(&mut self) -> FUN_WPU_W<'_, GPIO_SPEC>

Bit 8 - Pull-up enable of the pad. 1: internal pull-up enabled; 0: internal pull-up disabled.

pub fn fun_ie(&mut self) -> FUN_IE_W<'_, GPIO_SPEC>

Bit 9 - Input enable of the pad. 1: input enabled; 0: input disabled.

pub fn fun_drv(&mut self) -> FUN_DRV_W<'_, GPIO_SPEC>

Bits 10:11 - Select the drive strength of the pad. 0: ~5 mA; 1: ~10mA; 2: ~20mA; 3: ~40mA.

pub fn mcu_sel(&mut self) -> MCU_SEL_W<'_, GPIO_SPEC>

Bits 12:14 - Select IO MUX function for this signal. 0: Select Function 1; 1: Select Function 2; etc.

pub fn filter_en(&mut self) -> FILTER_EN_W<'_, GPIO_SPEC>

Bit 15 - Enable filter for pin input signals. 1: Filter enabled; 2: Filter disabled.