Struct esp32c3::uart0::conf1::R

pub struct R(_);

Register CONF1 reader

Implementations

impl R

pub fn rxfifo_full_thrhd(&self) -> RXFIFO_FULL_THRHD_R

Bits 0:8 - It will produce rxfifo_full_int interrupt when receiver receives more data than this register value.

pub fn txfifo_empty_thrhd(&self) -> TXFIFO_EMPTY_THRHD_R

Bits 9:17 - It will produce txfifo_empty_int interrupt when the data amount in Tx-FIFO is less than this register value.

pub fn dis_rx_dat_ovf(&self) -> DIS_RX_DAT_OVF_R

Bit 18 - Disable UART Rx data overflow detect.

pub fn rx_tout_flow_dis(&self) -> RX_TOUT_FLOW_DIS_R

Bit 19 - Set this bit to stop accumulating idle_cnt when hardware flow control works.

pub fn rx_flow_en(&self) -> RX_FLOW_EN_R

Bit 20 - This is the flow enable bit for UART receiver.

pub fn rx_tout_en(&self) -> RX_TOUT_EN_R

Bit 21 - This is the enble bit for uart receiver’s timeout function.

Methods from Deref<Target = R<CONF1_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CONF1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<CONF1_SPEC>> for R

fn from(reader: R<CONF1_SPEC>) -> Self

Converts to this type from the input type.