Struct esp32c3::io_mux::gpio::W

pub struct W(_);

Register GPIO%s writer

Implementations

impl W

pub fn mcu_oe(&mut self) -> MCU_OE_W<'_>

Bit 0 - Output enable of the pad in sleep mode. 1: output enabled; 0: output disabled.

pub fn slp_sel(&mut self) -> SLP_SEL_W<'_>

Bit 1 - Sleep mode selection of this pad. Set to 1 to put the pad in pad mode.

pub fn mcu_wpd(&mut self) -> MCU_WPD_W<'_>

Bit 2 - Pull-down enable of the pad in sleep mode. 1: internal pull-down enabled; 0: internal pull-down disabled.

pub fn mcu_wpu(&mut self) -> MCU_WPU_W<'_>

Bit 3 - Pull-up enable of the pad during sleep mode. 1: internal pull-up enabled; 0: internal pull-up disabled.

pub fn mcu_ie(&mut self) -> MCU_IE_W<'_>

Bit 4 - Input enable of the pad during sleep mode. 1: input enabled; 0: input disabled.

pub fn fun_wpd(&mut self) -> FUN_WPD_W<'_>

Bit 7 - Pull-down enable of the pad. 1: internal pull-down enabled; 0: internal pull-down disabled.

pub fn fun_wpu(&mut self) -> FUN_WPU_W<'_>

Bit 8 - Pull-up enable of the pad. 1: internal pull-up enabled; 0: internal pull-up disabled.

pub fn fun_ie(&mut self) -> FUN_IE_W<'_>

Bit 9 - Input enable of the pad. 1: input enabled; 0: input disabled.

pub fn fun_drv(&mut self) -> FUN_DRV_W<'_>

Bits 10:11 - Select the drive strength of the pad. 0: ~5 mA; 1: ~10mA; 2: ~20mA; 3: ~40mA.

pub fn mcu_sel(&mut self) -> MCU_SEL_W<'_>

Bits 12:14 - Select IO MUX function for this signal. 0: Select Function 1; 1: Select Function 2; etc.

pub fn filter_en(&mut self) -> FILTER_EN_W<'_>

Bit 15 - Enable filter for pin input signals. 1: Filter enabled; 2: Filter disabled.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<GPIO_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<GPIO_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<GPIO_SPEC>> for W

fn from(writer: W<GPIO_SPEC>) -> Self

Performs the conversion.