Struct esp32c3::gpio::pin::W

pub struct W(_);

Register PIN%s writer

Implementations

impl W

pub fn pin_sync2_bypass(&mut self) -> PIN_SYNC2_BYPASS_W<'_>

Bits 0:1 - set GPIO input_sync2 signal mode. :disable. 1:trigger at negedge. 2or3:trigger at posedge.

pub fn pin_pad_driver(&mut self) -> PIN_PAD_DRIVER_W<'_>

Bit 2 - set this bit to select pad driver. 1:open-drain. :normal.

pub fn pin_sync1_bypass(&mut self) -> PIN_SYNC1_BYPASS_W<'_>

Bits 3:4 - set GPIO input_sync1 signal mode. :disable. 1:trigger at negedge. 2or3:trigger at posedge.

pub fn pin_int_type(&mut self) -> PIN_INT_TYPE_W<'_>

Bits 7:9 - set this value to choose interrupt mode. :disable GPIO interrupt. 1:trigger at posedge. 2:trigger at negedge. 3:trigger at any edge. 4:valid at low level. 5:valid at high level

pub fn pin_wakeup_enable(&mut self) -> PIN_WAKEUP_ENABLE_W<'_>

Bit 10 - set this bit to enable GPIO wakeup.(can only wakeup CPU from Light-sleep Mode)

pub fn pin_config(&mut self) -> PIN_CONFIG_W<'_>

Bits 11:12 - reserved

pub fn pin_int_ena(&mut self) -> PIN_INT_ENA_W<'_>

Bits 13:17 - set bit 13 to enable CPU interrupt. set bit 14 to enable CPU(not shielded) interrupt.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<PIN_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<PIN_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<PIN_SPEC>> for W

fn from(writer: W<PIN_SPEC>) -> Self

Performs the conversion.