Struct esp32c3::dma::in_conf0_ch2::R

pub struct R(_);

Register IN_CONF0_CH2 reader

Implementations

impl R

pub fn in_rst_ch2(&self) -> IN_RST_CH2_R

Bit 0 - This bit is used to reset DMA channel 2 Rx FSM and Rx FIFO pointer.

pub fn in_loop_test_ch2(&self) -> IN_LOOP_TEST_CH2_R

Bit 1 - reserved

pub fn indscr_burst_en_ch2(&self) -> INDSCR_BURST_EN_CH2_R

Bit 2 - Set this bit to 1 to enable INCR burst transfer for Rx channel 2 reading link descriptor when accessing internal SRAM.

pub fn in_data_burst_en_ch2(&self) -> IN_DATA_BURST_EN_CH2_R

Bit 3 - Set this bit to 1 to enable INCR burst transfer for Rx channel 2 receiving data when accessing internal SRAM.

pub fn mem_trans_en_ch2(&self) -> MEM_TRANS_EN_CH2_R

Bit 4 - Set this bit 1 to enable automatic transmitting data from memory to memory via DMA.

Methods from Deref<Target = R<IN_CONF0_CH2_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<IN_CONF0_CH2_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<IN_CONF0_CH2_SPEC>> for R

fn from(reader: R<IN_CONF0_CH2_SPEC>) -> Self

Performs the conversion.