Struct esp32c3::uart0::rs485_conf::W

pub struct W(_);

Register RS485_CONF writer

Implementations

impl W

pub fn rs485_en(&mut self) -> RS485_EN_W<'_, 0>

Bit 0 - Set this bit to choose the rs485 mode.

pub fn dl0_en(&mut self) -> DL0_EN_W<'_, 1>

Bit 1 - Set this bit to delay the stop bit by 1 bit.

pub fn dl1_en(&mut self) -> DL1_EN_W<'_, 2>

Bit 2 - Set this bit to delay the stop bit by 1 bit.

pub fn rs485tx_rx_en(&mut self) -> RS485TX_RX_EN_W<'_, 3>

Bit 3 - Set this bit to enable receiver could receive data when the transmitter is transmitting data in rs485 mode.

pub fn rs485rxby_tx_en(&mut self) -> RS485RXBY_TX_EN_W<'_, 4>

Bit 4 - 1’h1: enable rs485 transmitter to send data when rs485 receiver line is busy.

pub fn rs485_rx_dly_num(&mut self) -> RS485_RX_DLY_NUM_W<'_, 5>

Bit 5 - This register is used to delay the receiver’s internal data signal.

pub fn rs485_tx_dly_num(&mut self) -> RS485_TX_DLY_NUM_W<'_, 6>

Bits 6:9 - This register is used to delay the transmitter’s internal data signal.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<RS485_CONF_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<RS485_CONF_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<RS485_CONF_SPEC>> for W

fn from(writer: W<RS485_CONF_SPEC>) -> Self

Converts to this type from the input type.