Struct esp32c3::uart0::conf1::W

pub struct W(_);

Register CONF1 writer

Implementations

impl W

pub fn rxfifo_full_thrhd(&mut self) -> RXFIFO_FULL_THRHD_W<'_, 0>

Bits 0:8 - It will produce rxfifo_full_int interrupt when receiver receives more data than this register value.

pub fn txfifo_empty_thrhd(&mut self) -> TXFIFO_EMPTY_THRHD_W<'_, 9>

Bits 9:17 - It will produce txfifo_empty_int interrupt when the data amount in Tx-FIFO is less than this register value.

pub fn dis_rx_dat_ovf(&mut self) -> DIS_RX_DAT_OVF_W<'_, 18>

Bit 18 - Disable UART Rx data overflow detect.

pub fn rx_tout_flow_dis(&mut self) -> RX_TOUT_FLOW_DIS_W<'_, 19>

Bit 19 - Set this bit to stop accumulating idle_cnt when hardware flow control works.

pub fn rx_flow_en(&mut self) -> RX_FLOW_EN_W<'_, 20>

Bit 20 - This is the flow enable bit for UART receiver.

pub fn rx_tout_en(&mut self) -> RX_TOUT_EN_W<'_, 21>

Bit 21 - This is the enble bit for uart receiver’s timeout function.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<CONF1_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<CONF1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<CONF1_SPEC>> for W

fn from(writer: W<CONF1_SPEC>) -> Self

Converts to this type from the input type.