Struct esp32c3::usb_device::int_raw::R

pub struct R(_);

Register INT_RAW reader

Implementations

impl R

pub fn jtag_in_flush_int_raw(&self) -> JTAG_IN_FLUSH_INT_RAW_R

Bit 0 - The raw interrupt bit turns to high level when flush cmd is received for IN endpoint 2 of JTAG.

pub fn sof_int_raw(&self) -> SOF_INT_RAW_R

Bit 1 - The raw interrupt bit turns to high level when SOF frame is received.

pub fn serial_out_recv_pkt_int_raw(&self) -> SERIAL_OUT_RECV_PKT_INT_RAW_R

Bit 2 - The raw interrupt bit turns to high level when Serial Port OUT Endpoint received one packet.

pub fn serial_in_empty_int_raw(&self) -> SERIAL_IN_EMPTY_INT_RAW_R

Bit 3 - The raw interrupt bit turns to high level when Serial Port IN Endpoint is empty.

pub fn pid_err_int_raw(&self) -> PID_ERR_INT_RAW_R

Bit 4 - The raw interrupt bit turns to high level when pid error is detected.

pub fn crc5_err_int_raw(&self) -> CRC5_ERR_INT_RAW_R

Bit 5 - The raw interrupt bit turns to high level when CRC5 error is detected.

pub fn crc16_err_int_raw(&self) -> CRC16_ERR_INT_RAW_R

Bit 6 - The raw interrupt bit turns to high level when CRC16 error is detected.

pub fn stuff_err_int_raw(&self) -> STUFF_ERR_INT_RAW_R

Bit 7 - The raw interrupt bit turns to high level when stuff error is detected.

pub fn in_token_rec_in_ep1_int_raw(&self) -> IN_TOKEN_REC_IN_EP1_INT_RAW_R

Bit 8 - The raw interrupt bit turns to high level when IN token for IN endpoint 1 is received.

pub fn usb_bus_reset_int_raw(&self) -> USB_BUS_RESET_INT_RAW_R

Bit 9 - The raw interrupt bit turns to high level when usb bus reset is detected.

pub fn out_ep1_zero_payload_int_raw(&self) -> OUT_EP1_ZERO_PAYLOAD_INT_RAW_R

Bit 10 - The raw interrupt bit turns to high level when OUT endpoint 1 received packet with zero palyload.

pub fn out_ep2_zero_payload_int_raw(&self) -> OUT_EP2_ZERO_PAYLOAD_INT_RAW_R

Bit 11 - The raw interrupt bit turns to high level when OUT endpoint 2 received packet with zero palyload.

Methods from Deref<Target = R<INT_RAW_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<INT_RAW_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<INT_RAW_SPEC>> for R

fn from(reader: R<INT_RAW_SPEC>) -> Self

Converts to this type from the input type.