Struct esp32c3::uart0::id::R

pub struct R(_);

Register ID reader

Implementations

impl R

pub fn id(&self) -> ID_R

Bits 0:29 - This register is used to configure the uart_id.

pub fn high_speed(&self) -> HIGH_SPEED_R

Bit 30 - This bit used to select synchronize mode. 1: Registers are auto synchronized into UART Core clock and UART core should be keep the same with APB clock. 0: After configure registers, software needs to write 1 to UART_REG_UPDATE to synchronize registers.

pub fn reg_update(&self) -> REG_UPDATE_R

Bit 31 - Software write 1 would synchronize registers into UART Core clock domain and would be cleared by hardware after synchronization is done.

Methods from Deref<Target = R<ID_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<ID_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<ID_SPEC>> for R

fn from(reader: R<ID_SPEC>) -> Self

Converts to this type from the input type.