Struct esp32c3_hal::pulse_control::Channel0

pub struct Channel0 { /* private fields */ }

RX/TX Input/Output Channel

Implementations

impl Channel0

pub fn new() -> Channel0

Create a new channel instance

Trait Implementations

impl OutputChannel for Channel0

fn set_idle_output_level(&mut self, level: bool) -> &mut Channel0

Set the logical level that the connected pin is pulled to while the channel is idle

fn set_idle_output(&mut self, state: bool) -> &mut Channel0

Enable/Disable the output while the channel is idle

fn set_channel_divider(&mut self, divider: u8) -> &mut Channel0

Set channel clock divider value

fn set_carrier_modulation(&mut self, state: bool) -> &mut Channel0

Enable/Disable carrier modulation

fn assign_pin<RmtPin>(&mut self, pin: RmtPin) -> &mut Channel0where
    RmtPin: OutputPin,

Assign a pin that should be driven by this channel

fn send_pulse_sequence<const N: usize>(
    &mut self,
    repeat_mode: RepeatMode,
    sequence: &[PulseCode; N]
) -> Result<(), TransmissionError>

Send a pulse sequence in a blocking fashion

fn send_pulse_sequence_raw<const N: usize>(
    &mut self,
    repeat_mode: RepeatMode,
    sequence: &[u32; N]
) -> Result<(), TransmissionError>

Send a raw pulse sequence in a blocking fashion

In this function we expect the sequence elements to be already in the correct u32 format that is understood by the RMT. Please refer to the reference manual or use the variant which accepts PulseCode objects instead.

We expect that the end marker is already part of the provided sequence and to be provided in all modes!

fn stop_transmission(&self)

Stop any ongoing (repetitive) transmission

This function needs to be called to stop sending when previously a sequence was sent with RepeatMode::Forever.