Struct esp32c2::i2c0::fifo_conf::W

pub struct W(_);

Register FIFO_CONF writer

Implementations

impl W

pub fn rxfifo_wm_thrhd(&mut self) -> RXFIFO_WM_THRHD_W<'_, 0>

Bits 0:3 - The water mark threshold of rx FIFO in nonfifo access mode. When reg_reg_fifo_prt_en is 1 and rx FIFO counter is bigger than reg_rxfifo_wm_thrhd[3:0], reg_rxfifo_wm_int_raw bit will be valid.

pub fn txfifo_wm_thrhd(&mut self) -> TXFIFO_WM_THRHD_W<'_, 5>

Bits 5:8 - The water mark threshold of tx FIFO in nonfifo access mode. When reg_reg_fifo_prt_en is 1 and tx FIFO counter is smaller than reg_txfifo_wm_thrhd[3:0], reg_txfifo_wm_int_raw bit will be valid.

pub fn nonfifo_en(&mut self) -> NONFIFO_EN_W<'_, 10>

Bit 10 - Set this bit to enable APB nonfifo access.

pub fn rx_fifo_rst(&mut self) -> RX_FIFO_RST_W<'_, 12>

Bit 12 - Set this bit to reset rx-fifo.

pub fn tx_fifo_rst(&mut self) -> TX_FIFO_RST_W<'_, 13>

Bit 13 - Set this bit to reset tx-fifo.

pub fn fifo_prt_en(&mut self) -> FIFO_PRT_EN_W<'_, 14>

Bit 14 - The control enable bit of FIFO pointer in non-fifo access mode. This bit controls the valid bits and the interrupts of tx/rx_fifo overflow, underflow, full and empty.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<FIFO_CONF_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<FIFO_CONF_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<FIFO_CONF_SPEC>> for W

fn from(writer: W<FIFO_CONF_SPEC>) -> Self

Converts to this type from the input type.