Struct esp32c2::uart0::mem_conf::W

pub struct W(_);

Register MEM_CONF writer

Implementations

impl W

pub fn rx_size(&mut self) -> RX_SIZE_W<'_, 1>

Bits 1:3 - This register is used to configure the amount of mem allocated for receive-FIFO. The default number is 128 bytes.

pub fn tx_size(&mut self) -> TX_SIZE_W<'_, 4>

Bits 4:6 - This register is used to configure the amount of mem allocated for transmit-FIFO. The default number is 128 bytes.

pub fn rx_flow_thrhd(&mut self) -> RX_FLOW_THRHD_W<'_, 7>

Bits 7:15 - This register is used to configure the maximum amount of data that can be received when hardware flow control works.

pub fn rx_tout_thrhd(&mut self) -> RX_TOUT_THRHD_W<'_, 16>

Bits 16:25 - This register is used to configure the threshold time that receiver takes to receive one byte. The rxfifo_tout_int interrupt will be trigger when the receiver takes more time to receive one byte with rx_tout_en set to 1.

pub fn mem_force_pd(&mut self) -> MEM_FORCE_PD_W<'_, 26>

Bit 26 - Set this bit to force power down UART memory.

pub fn mem_force_pu(&mut self) -> MEM_FORCE_PU_W<'_, 27>

Bit 27 - Set this bit to force power up UART memory.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<MEM_CONF_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<MEM_CONF_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<MEM_CONF_SPEC>> for W

fn from(writer: W<MEM_CONF_SPEC>) -> Self

Converts to this type from the input type.