Struct esp32c2::ledc::ch_conf1::W

pub struct W(_);

Register CH%s_CONF1 writer

Implementations

impl W

pub fn duty_scale(&mut self) -> DUTY_SCALE_W<'_, 0>

Bits 0:9 - This register is used to configure the changing step scale of duty on channel %s.

pub fn duty_cycle(&mut self) -> DUTY_CYCLE_W<'_, 10>

Bits 10:19 - The duty will change every LEDC_DUTY_CYCLE_CH%s on channel %s.

pub fn duty_num(&mut self) -> DUTY_NUM_W<'_, 20>

Bits 20:29 - This register is used to control the number of times the duty cycle will be changed.

pub fn duty_inc(&mut self) -> DUTY_INC_W<'_, 30>

Bit 30 - This register is used to increase or decrease the duty of output signal on channel %s. 1: Increase; 0: Decrease.

pub fn duty_start(&mut self) -> DUTY_START_W<'_, 31>

Bit 31 - Other configured fields in LEDC_CH%s_CONF1_REG will start to take effect when this bit is set to 1.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<CH_CONF1_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<CH_CONF1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<CH_CONF1_SPEC>> for W

fn from(writer: W<CH_CONF1_SPEC>) -> Self

Converts to this type from the input type.