Struct esp32c2::ledc::ch_conf0::R

pub struct R(_);

Register CH%s_CONF0 reader

Implementations

impl R

pub fn timer_sel(&self) -> TIMER_SEL_R

Bits 0:1 - This field is used to select one of timers for channel %s. 0: select timer0; 1: select timer1; 2: select timer2; 3: select timer3

pub fn sig_out_en(&self) -> SIG_OUT_EN_R

Bit 2 - Set this bit to enable signal output on channel %s.

pub fn idle_lv(&self) -> IDLE_LV_R

Bit 3 - This bit is used to control the output value when channel %s is inactive (when LEDC_SIG_OUT_EN_CH%s is 0).

pub fn ovf_num(&self) -> OVF_NUM_R

Bits 5:14 - This register is used to configure the maximum times of overflow minus 1. The LEDC_OVF_CNT_CH%s_INT interrupt will be triggered when channel %s overflows for (LEDC_OVF_NUM_CH%s + 1) times.

pub fn ovf_cnt_en(&self) -> OVF_CNT_EN_R

Bit 15 - This bit is used to enable the ovf_cnt of channel %s.

Methods from Deref<Target = R<CH_CONF0_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CH_CONF0_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<CH_CONF0_SPEC>> for R

fn from(reader: R<CH_CONF0_SPEC>) -> Self

Converts to this type from the input type.