Struct esp32c2::spi0::misc::R

pub struct R(_);

Register MISC reader

Implementations

impl R

pub fn trans_end(&self) -> TRANS_END_R

Bit 3 - The bit is used to indicate the spi0_mst_st controlled transmitting is done.

pub fn trans_end_int_ena(&self) -> TRANS_END_INT_ENA_R

Bit 4 - The bit is used to enable the interrupt of spi0_mst_st controlled transmitting is done.

pub fn cspi_st_trans_end(&self) -> CSPI_ST_TRANS_END_R

Bit 5 - The bit is used to indicate the spi0_slv_st controlled transmitting is done.

pub fn cspi_st_trans_end_int_ena(&self) -> CSPI_ST_TRANS_END_INT_ENA_R

Bit 6 - The bit is used to enable the interrupt of spi0_slv_st controlled transmitting is done.

pub fn ck_idle_edge(&self) -> CK_IDLE_EDGE_R

Bit 9 - 1: spi clk line is high when idle 0: spi clk line is low when idle

pub fn cs_keep_active(&self) -> CS_KEEP_ACTIVE_R

Bit 10 - spi cs line keep low when the bit is set.

Methods from Deref<Target = R<MISC_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<MISC_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<MISC_SPEC>> for R

fn from(reader: R<MISC_SPEC>) -> Self

Converts to this type from the input type.