Struct esp32c2::ecc::mult_conf::W

pub struct W(_);

Register MULT_CONF writer

Implementations

impl W

pub fn start(&mut self) -> START_W<'_, 0>

Bit 0 - Set this bit to reset receiver

pub fn reset(&mut self) -> RESET_W<'_, 1>

Bit 1 - Set this bit to reset Rx AFIFO

pub fn key_length(&mut self) -> KEY_LENGTH_W<'_, 2>

Bit 2 - Set this bit to start receiving data

pub fn security_mode(&mut self) -> SECURITY_MODE_W<'_, 3>

Bit 3 - Set this bit to enable slave receiver mode

pub fn clk_en(&mut self) -> CLK_EN_W<'_, 4>

Bit 4 - clk gate

pub fn work_mode(&mut self) -> WORK_MODE_W<'_, 5>

Bits 5:7 - Reserved

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<MULT_CONF_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<MULT_CONF_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<MULT_CONF_SPEC>> for W

fn from(writer: W<MULT_CONF_SPEC>) -> Self

Converts to this type from the input type.