Struct esp32c2::spi0::spi_mem_ctrl::R

pub struct R(_);

Register SPI_MEM_CTRL reader

Implementations

impl R

pub fn spi_mem_fdummy_out(&self) -> SPI_MEM_FDUMMY_OUT_R

Bit 3 - In the dummy phase the signal level of spi is output by the spi controller.

pub fn spi_mem_fcmd_dual(&self) -> SPI_MEM_FCMD_DUAL_R

Bit 7 - Apply 2 signals during command phase 1:enable 0: disable

pub fn spi_mem_fcmd_quad(&self) -> SPI_MEM_FCMD_QUAD_R

Bit 8 - Apply 4 signals during command phase 1:enable 0: disable

pub fn spi_mem_fastrd_mode(&self) -> SPI_MEM_FASTRD_MODE_R

Bit 13 - This bit enable the bits: SPI_MEM_FREAD_QIO, SPI_MEM_FREAD_DIO, SPI_MEM_FREAD_QOUT AND SPI_MEM_FREAD_DOUT. 1: enable 0: disable.

pub fn spi_mem_fread_dual(&self) -> SPI_MEM_FREAD_DUAL_R

Bit 14 - In the read operations, read-data phase apply 2 signals. 1: enable 0: disable.

pub fn spi_mem_q_pol(&self) -> SPI_MEM_Q_POL_R

Bit 18 - The bit is used to set MISO line polarity, 1: high 0, low

pub fn spi_mem_d_pol(&self) -> SPI_MEM_D_POL_R

Bit 19 - The bit is used to set MOSI line polarity, 1: high 0, low

pub fn spi_mem_fread_quad(&self) -> SPI_MEM_FREAD_QUAD_R

Bit 20 - In the read operations read-data phase apply 4 signals. 1: enable 0: disable.

pub fn spi_mem_wp(&self) -> SPI_MEM_WP_R

Bit 21 - Write protect signal output when SPI is idle. 1: output high, 0: output low.

pub fn spi_mem_fread_dio(&self) -> SPI_MEM_FREAD_DIO_R

Bit 23 - In the read operations address phase and read-data phase apply 2 signals. 1: enable 0: disable.

pub fn spi_mem_fread_qio(&self) -> SPI_MEM_FREAD_QIO_R

Bit 24 - In the read operations address phase and read-data phase apply 4 signals. 1: enable 0: disable.

Methods from Deref<Target = R<SPI_MEM_CTRL_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<SPI_MEM_CTRL_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<SPI_MEM_CTRL_SPEC>> for R

fn from(reader: R<SPI_MEM_CTRL_SPEC>) -> Self

Converts to this type from the input type.