Struct esp32c2_hal::pac::uart0::rs485_conf::R

pub struct R(_);

Register RS485_CONF reader

Implementations

impl R

pub fn rs485_en(&self) -> BitReaderRaw<bool>

Bit 0 - Set this bit to choose the rs485 mode.

pub fn dl0_en(&self) -> BitReaderRaw<bool>

Bit 1 - Set this bit to delay the stop bit by 1 bit.

pub fn dl1_en(&self) -> BitReaderRaw<bool>

Bit 2 - Set this bit to delay the stop bit by 1 bit.

pub fn rs485tx_rx_en(&self) -> BitReaderRaw<bool>

Bit 3 - Set this bit to enable receiver could receive data when the transmitter is transmitting data in rs485 mode.

pub fn rs485rxby_tx_en(&self) -> BitReaderRaw<bool>

Bit 4 - 1’h1: enable rs485 transmitter to send data when rs485 receiver line is busy.

pub fn rs485_rx_dly_num(&self) -> BitReaderRaw<bool>

Bit 5 - This register is used to delay the receiver’s internal data signal.

pub fn rs485_tx_dly_num(&self) -> FieldReaderRaw<u8, u8>

Bits 6:9 - This register is used to delay the transmitter’s internal data signal.

Methods from Deref<Target = R<RS485_CONF_SPEC>>

pub fn bits(&self) -> <REG as RegisterSpec>::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<RS485_CONF_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<R as Deref>::Target

Dereferences the value.

impl From<R<RS485_CONF_SPEC>> for R

fn from(reader: R<RS485_CONF_SPEC>) -> R

Converts to this type from the input type.