Struct esp32c2_hal::pac::uart0::flow_conf::W

pub struct W(_);

Register FLOW_CONF writer

Implementations

impl W

pub fn sw_flow_con_en(
    &mut self
) -> BitWriterRaw<'_, u32, FLOW_CONF_SPEC, bool, BitM, 0>

Bit 0 - Set this bit to enable software flow control. It is used with register sw_xon or sw_xoff.

pub fn xonoff_del(
    &mut self
) -> BitWriterRaw<'_, u32, FLOW_CONF_SPEC, bool, BitM, 1>

Bit 1 - Set this bit to remove flow control char from the received data.

pub fn force_xon(
    &mut self
) -> BitWriterRaw<'_, u32, FLOW_CONF_SPEC, bool, BitM, 2>

Bit 2 - Set this bit to enable the transmitter to go on sending data.

pub fn force_xoff(
    &mut self
) -> BitWriterRaw<'_, u32, FLOW_CONF_SPEC, bool, BitM, 3>

Bit 3 - Set this bit to stop the transmitter from sending data.

pub fn send_xon(
    &mut self
) -> BitWriterRaw<'_, u32, FLOW_CONF_SPEC, bool, BitM, 4>

Bit 4 - Set this bit to send Xon char. It is cleared by hardware automatically.

pub fn send_xoff(
    &mut self
) -> BitWriterRaw<'_, u32, FLOW_CONF_SPEC, bool, BitM, 5>

Bit 5 - Set this bit to send Xoff char. It is cleared by hardware automatically.

pub unsafe fn bits(&mut self, bits: u32) -> &mut W

Writes raw bits to the register.

Methods from Deref<Target = W<FLOW_CONF_SPEC>>

pub unsafe fn bits(&mut self, bits: <REG as RegisterSpec>::Ux) -> &mut W<REG>

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<FLOW_CONF_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<W as Deref>::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut <W as Deref>::Target

Mutably dereferences the value.

impl From<W<FLOW_CONF_SPEC>> for W

fn from(writer: W<FLOW_CONF_SPEC>) -> W

Converts to this type from the input type.