Struct esp32c2_hal::pac::spi0::misc::W

pub struct W(_);

Register MISC writer

Implementations

impl W

pub fn trans_end(&mut self) -> BitWriterRaw<'_, u32, MISC_SPEC, bool, BitM, 3>

Bit 3 - The bit is used to indicate the spi0_mst_st controlled transmitting is done.

pub fn trans_end_int_ena(
    &mut self
) -> BitWriterRaw<'_, u32, MISC_SPEC, bool, BitM, 4>

Bit 4 - The bit is used to enable the interrupt of spi0_mst_st controlled transmitting is done.

pub fn cspi_st_trans_end(
    &mut self
) -> BitWriterRaw<'_, u32, MISC_SPEC, bool, BitM, 5>

Bit 5 - The bit is used to indicate the spi0_slv_st controlled transmitting is done.

pub fn cspi_st_trans_end_int_ena(
    &mut self
) -> BitWriterRaw<'_, u32, MISC_SPEC, bool, BitM, 6>

Bit 6 - The bit is used to enable the interrupt of spi0_slv_st controlled transmitting is done.

pub fn ck_idle_edge(
    &mut self
) -> BitWriterRaw<'_, u32, MISC_SPEC, bool, BitM, 9>

Bit 9 - 1: spi clk line is high when idle 0: spi clk line is low when idle

pub fn cs_keep_active(
    &mut self
) -> BitWriterRaw<'_, u32, MISC_SPEC, bool, BitM, 10>

Bit 10 - spi cs line keep low when the bit is set.

pub unsafe fn bits(&mut self, bits: u32) -> &mut W

Writes raw bits to the register.

Methods from Deref<Target = W<MISC_SPEC>>

pub unsafe fn bits(&mut self, bits: <REG as RegisterSpec>::Ux) -> &mut W<REG>

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<MISC_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<W as Deref>::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut <W as Deref>::Target

Mutably dereferences the value.

impl From<W<MISC_SPEC>> for W

fn from(writer: W<MISC_SPEC>) -> W

Converts to this type from the input type.