Type Alias esp32::uart0::rs485_conf::R

pub type R = R<RS485_CONF_SPEC>;

Register RS485_CONF reader

Implementations

impl R

pub fn rs485_en(&self) -> RS485_EN_R

Bit 0 - Set this bit to choose rs485 mode.

pub fn dl0_en(&self) -> DL0_EN_R

Bit 1 - Set this bit to delay the stop bit by 1 bit.

pub fn dl1_en(&self) -> DL1_EN_R

Bit 2 - Set this bit to delay the stop bit by 1 bit.

pub fn rs485tx_rx_en(&self) -> RS485TX_RX_EN_R

Bit 3 - Set this bit to enable loopback transmitter’s output data signal to receiver’s input data signal.

pub fn rs485rxby_tx_en(&self) -> RS485RXBY_TX_EN_R

Bit 4 - 1: enable rs485’s transmitter to send data when rs485’s receiver is busy. 0:rs485’s transmitter should not send data when its receiver is busy.

pub fn rs485_rx_dly_num(&self) -> RS485_RX_DLY_NUM_R

Bit 5 - This register is used to delay the receiver’s internal data signal.

pub fn rs485_tx_dly_num(&self) -> RS485_TX_DLY_NUM_R

Bits 6:9 - This register is used to delay the transmitter’s internal data signal.