Struct esp32::i2c0::comd::R

pub struct R(_);

Register COMD%s reader

Implementations

impl R

pub fn command(&self) -> COMMAND_R

Bits 0:13 - This is the content of command0. It consists of three part. op_code is the command 0: RSTART 1: WRITE 2: READ 3: STOP . 4:END. Byte_num represent the number of data need to be send or data need to be received. ack_check_en ack_exp and ack value are used to control the ack bit.

pub fn command_done(&self) -> COMMAND_DONE_R

Bit 31 - When command0 is done in I2C Master mode this bit changes to high level.

Methods from Deref<Target = R<COMD_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<COMD_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<COMD_SPEC>> for R

fn from(reader: R<COMD_SPEC>) -> Self

Converts to this type from the input type.