Struct esp32::rtc_io::touch_pad3::W

pub struct W(_);

Register TOUCH_PAD3 writer

Implementations

impl W

pub fn to_gpio(&mut self) -> TO_GPIO_W<'_, 12>

Bit 12 - connect the rtc pad input to digital pad input Ó0Ó is availbale.MTDO

pub fn fun_ie(&mut self) -> FUN_IE_W<'_, 13>

Bit 13 - the input enable of the pad

pub fn slp_oe(&mut self) -> SLP_OE_W<'_, 14>

Bit 14 - the output enable of the pad in sleep status

pub fn slp_ie(&mut self) -> SLP_IE_W<'_, 15>

Bit 15 - the input enable of the pad in sleep status

pub fn slp_sel(&mut self) -> SLP_SEL_W<'_, 16>

Bit 16 - the sleep status selection signal of the pad

pub fn fun_sel(&mut self) -> FUN_SEL_W<'_, 17>

Bits 17:18 - the functional selection signal of the pad

pub fn mux_sel(&mut self) -> MUX_SEL_W<'_, 19>

Bit 19 - Ò1Ó select the digital function Ó0Óslection the rtc function

pub fn xpd(&mut self) -> XPD_W<'_, 20>

Bit 20 - touch sensor power on.

pub fn tie_opt(&mut self) -> TIE_OPT_W<'_, 21>

Bit 21 - default touch sensor tie option. 0: tie low 1: tie high.

pub fn start(&mut self) -> START_W<'_, 22>

Bit 22 - start touch sensor.

pub fn dac(&mut self) -> DAC_W<'_, 23>

Bits 23:25 - touch sensor slope control. 3-bit for each touch panel default 100.

pub fn rue(&mut self) -> RUE_W<'_, 27>

Bit 27 - the pull up enable of the pad

pub fn rde(&mut self) -> RDE_W<'_, 28>

Bit 28 - the pull down enable of the pad

pub fn drv(&mut self) -> DRV_W<'_, 29>

Bits 29:30 - the driver strength of the pad

pub fn hold(&mut self) -> HOLD_W<'_, 31>

Bit 31 - hold the current value of the output when setting the hold to Ò1Ó

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<TOUCH_PAD3_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<TOUCH_PAD3_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<TOUCH_PAD3_SPEC>> for W

fn from(writer: W<TOUCH_PAD3_SPEC>) -> Self

Converts to this type from the input type.