Struct esp32::rtcio::touch_pad2::R

pub struct R(_);

Register TOUCH_PAD2 reader

Implementations

impl R

pub fn to_gpio(&self) -> TO_GPIO_R

Bit 12 - connect the rtc pad input to digital pad input Ó0Ó is availbale.GPIO2

pub fn fun_ie(&self) -> FUN_IE_R

Bit 13 - the input enable of the pad

pub fn slp_oe(&self) -> SLP_OE_R

Bit 14 - the output enable of the pad in sleep status

pub fn slp_ie(&self) -> SLP_IE_R

Bit 15 - the input enable of the pad in sleep status

pub fn slp_sel(&self) -> SLP_SEL_R

Bit 16 - the sleep status selection signal of the pad

pub fn fun_sel(&self) -> FUN_SEL_R

Bits 17:18 - the functional selection signal of the pad

pub fn mux_sel(&self) -> MUX_SEL_R

Bit 19 - Ò1Ó select the digital function Ó0Óslection the rtc function

pub fn xpd(&self) -> XPD_R

Bit 20 - touch sensor power on.

pub fn tie_opt(&self) -> TIE_OPT_R

Bit 21 - default touch sensor tie option. 0: tie low 1: tie high.

pub fn start(&self) -> START_R

Bit 22 - start touch sensor.

pub fn dac(&self) -> DAC_R

Bits 23:25 - touch sensor slope control. 3-bit for each touch panel default 100.

pub fn rue(&self) -> RUE_R

Bit 27 - the pull up enable of the pad

pub fn rde(&self) -> RDE_R

Bit 28 - the pull down enable of the pad

pub fn drv(&self) -> DRV_R

Bits 29:30 - the driver strength of the pad

pub fn hold(&self) -> HOLD_R

Bit 31 - hold the current value of the output when setting the hold to Ò1Ó

Methods from Deref<Target = R<TOUCH_PAD2_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<TOUCH_PAD2_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<TOUCH_PAD2_SPEC>> for R

fn from(reader: R<TOUCH_PAD2_SPEC>) -> Self

Converts to this type from the input type.