Struct esp32::ledc::lsch_conf0::W

pub struct W(_);

Register LSCH%s_CONF0 writer

Implementations

impl W

pub fn timer_sel(&mut self) -> TIMER_SEL_W<'_, 0>

Bits 0:1 - There are four low speed timers the two bits are used to select one of them for low speed channel0. 2’b00: seletc lstimer0. 2’b01: select lstimer1. 2’b10: select lstimer2. 2’b11: select lstimer3.

pub fn sig_out_en(&mut self) -> SIG_OUT_EN_W<'_, 2>

Bit 2 - This is the output enable control bit for low speed channel0.

pub fn idle_lv(&mut self) -> IDLE_LV_W<'_, 3>

Bit 3 - This bit is used to control the output value when low speed channel0 is off.

pub fn para_up(&mut self) -> PARA_UP_W<'_, 4>

Bit 4 - This bit is used to update register LEDC_LSCH0_HPOINT and LEDC_LSCH0_DUTY for low speed channel0.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<LSCH_CONF0_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<LSCH_CONF0_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<LSCH_CONF0_SPEC>> for W

fn from(writer: W<LSCH_CONF0_SPEC>) -> Self

Converts to this type from the input type.