Struct esp32::ledc::hsch_conf1::W

pub struct W(_);

Register HSCH%s_CONF1 writer

Implementations

impl W

pub fn duty_scale(&mut self) -> DUTY_SCALE_W<'_, 0>

Bits 0:9 - This register controls the increase or decrease step scale for high speed channel0.

pub fn duty_cycle(&mut self) -> DUTY_CYCLE_W<'_, 10>

Bits 10:19 - This register is used to increase or decrease the duty every reg_duty_cycle_hsch0 cycles for high speed channel0.

pub fn duty_num(&mut self) -> DUTY_NUM_W<'_, 20>

Bits 20:29 - This register is used to control the num of increased or decreased times for high speed channel0.

pub fn duty_inc(&mut self) -> DUTY_INC_W<'_, 30>

Bit 30 - This register is used to increase the duty of output signal or decrease the duty of output signal for high speed channel0.

pub fn duty_start(&mut self) -> DUTY_START_W<'_, 31>

Bit 31 - When reg_duty_num_hsch0 reg_duty_cycle_hsch0 and reg_duty_scale_hsch0 has been configured. these register won’t take effect until set reg_duty_start_hsch0. this bit is automatically cleared by hardware.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<HSCH_CONF1_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<HSCH_CONF1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<HSCH_CONF1_SPEC>> for W

fn from(writer: W<HSCH_CONF1_SPEC>) -> Self

Converts to this type from the input type.