Struct esp32::spi0::slave::W

pub struct W(_);

Register SLAVE writer

Implementations

impl W

pub fn slv_rd_buf_done(&mut self) -> SLV_RD_BUF_DONE_W<'_, 0>

Bit 0 - The interrupt raw bit for the completion of read-buffer operation in the slave mode.

pub fn slv_wr_buf_done(&mut self) -> SLV_WR_BUF_DONE_W<'_, 1>

Bit 1 - The interrupt raw bit for the completion of write-buffer operation in the slave mode.

pub fn slv_rd_sta_done(&mut self) -> SLV_RD_STA_DONE_W<'_, 2>

Bit 2 - The interrupt raw bit for the completion of read-status operation in the slave mode.

pub fn slv_wr_sta_done(&mut self) -> SLV_WR_STA_DONE_W<'_, 3>

Bit 3 - The interrupt raw bit for the completion of write-status operation in the slave mode.

pub fn trans_done(&mut self) -> TRANS_DONE_W<'_, 4>

Bit 4 - The interrupt raw bit for the completion of any operation in both the master mode and the slave mode.

pub fn int_en(&mut self) -> INT_EN_W<'_, 5>

Bits 5:9 - Interrupt enable bits for the below 5 sources

pub fn cs_i_mode(&mut self) -> CS_I_MODE_W<'_, 10>

Bits 10:11 - In the slave mode this bits used to synchronize the input spi cs signal and eliminate spi cs jitter.

pub fn slv_cmd_define(&mut self) -> SLV_CMD_DEFINE_W<'_, 27>

Bit 27 - 1: slave mode commands are defined in SPI_SLAVE3. 0: slave mode commands are fixed as: 1: write-status 2: write-buffer and 3: read-buffer.

pub fn slv_wr_rd_sta_en(&mut self) -> SLV_WR_RD_STA_EN_W<'_, 28>

Bit 28 - write and read status enable in the slave mode

pub fn slv_wr_rd_buf_en(&mut self) -> SLV_WR_RD_BUF_EN_W<'_, 29>

Bit 29 - write and read buffer enable in the slave mode

pub fn mode(&mut self) -> MODE_W<'_, 30>

Bit 30 - 1: slave mode 0: master mode.

pub fn sync_reset(&mut self) -> SYNC_RESET_W<'_, 31>

Bit 31 - Software reset enable, reset the spi clock line cs line and data lines.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<SLAVE_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<SLAVE_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<SLAVE_SPEC>> for W

fn from(writer: W<SLAVE_SPEC>) -> Self

Converts to this type from the input type.