Struct esp32::sens::sar_touch_ctrl1::W

pub struct W(_);

Register SAR_TOUCH_CTRL1 writer

Implementations

impl W

pub fn touch_meas_delay(&mut self) -> TOUCH_MEAS_DELAY_W<'_, 0>

Bits 0:15 - the meas length (in 8MHz)

pub fn touch_xpd_wait(&mut self) -> TOUCH_XPD_WAIT_W<'_, 16>

Bits 16:23 - the waiting cycles (in 8MHz) between TOUCH_START and TOUCH_XPD

pub fn touch_out_sel(&mut self) -> TOUCH_OUT_SEL_W<'_, 24>

Bit 24 - 1: when the counter is greater then the threshold the touch pad is considered as “touched” 0: when the counter is less than the threshold the touch pad is considered as “touched”

pub fn touch_out_1en(&mut self) -> TOUCH_OUT_1EN_W<'_, 25>

Bit 25 - 1: wakeup interrupt is generated if SET1 is “touched” 0: wakeup interrupt is generated only if SET1 & SET2 is both “touched”

pub fn xpd_hall_force(&mut self) -> XPD_HALL_FORCE_W<'_, 26>

Bit 26 - 1: XPD HALL is controlled by SW. 0: XPD HALL is controlled by FSM in ULP-coprocessor

pub fn hall_phase_force(&mut self) -> HALL_PHASE_FORCE_W<'_, 27>

Bit 27 - 1: HALL PHASE is controlled by SW 0: HALL PHASE is controlled by FSM in ULP-coprocessor

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<SAR_TOUCH_CTRL1_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<SAR_TOUCH_CTRL1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<SAR_TOUCH_CTRL1_SPEC>> for W

fn from(writer: W<SAR_TOUCH_CTRL1_SPEC>) -> Self

Converts to this type from the input type.