Struct esp32::spi0::ctrl2::R

pub struct R(_);

Register CTRL2 reader

Implementations

impl R

pub fn setup_time(&self) -> SETUP_TIME_R

Bits 0:3 - (cycles-1) of ¡°prepare¡± phase by spi clock, this bits combined with spi_cs_setup bit.

pub fn hold_time(&self) -> HOLD_TIME_R

Bits 4:7 - delay cycles of cs pin by spi clock, this bits combined with spi_cs_hold bit.

pub fn ck_out_low_mode(&self) -> CK_OUT_LOW_MODE_R

Bits 8:11 - modify spi clock duty ratio when the value is lager than 8, the bits are combined with spi_clkcnt_N bits and spi_clkcnt_L bits.

pub fn ck_out_high_mode(&self) -> CK_OUT_HIGH_MODE_R

Bits 12:15 - modify spi clock duty ratio when the value is lager than 8, the bits are combined with spi_clkcnt_N bits and spi_clkcnt_H bits.

pub fn miso_delay_mode(&self) -> MISO_DELAY_MODE_R

Bits 16:17 - MISO signals are delayed by spi_clk. 0: zero 1: if spi_ck_out_edge or spi_ck_i_edge is set 1 delayed by half cycle else delayed by one cycle 2: if spi_ck_out_edge or spi_ck_i_edge is set 1 delayed by one cycle else delayed by half cycle 3: delayed one cycle

pub fn miso_delay_num(&self) -> MISO_DELAY_NUM_R

Bits 18:20 - MISO signals are delayed by system clock cycles

pub fn mosi_delay_mode(&self) -> MOSI_DELAY_MODE_R

Bits 21:22 - MOSI signals are delayed by spi_clk. 0: zero 1: if spi_ck_out_edge or spi_ck_i_edge is set 1 delayed by half cycle else delayed by one cycle 2: if spi_ck_out_edge or spi_ck_i_edge is set 1 delayed by one cycle else delayed by half cycle 3: delayed one cycle

pub fn mosi_delay_num(&self) -> MOSI_DELAY_NUM_R

Bits 23:25 - MOSI signals are delayed by system clock cycles

pub fn cs_delay_mode(&self) -> CS_DELAY_MODE_R

Bits 26:27 - spi_cs signal is delayed by spi_clk . 0: zero 1: if spi_ck_out_edge or spi_ck_i_edge is set 1 delayed by half cycle else delayed by one cycle 2: if spi_ck_out_edge or spi_ck_i_edge is set 1 delayed by one cycle else delayed by half cycle 3: delayed one cycle

pub fn cs_delay_num(&self) -> CS_DELAY_NUM_R

Bits 28:31 - spi_cs signal is delayed by system clock cycles

Methods from Deref<Target = R<CTRL2_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CTRL2_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<CTRL2_SPEC>> for R

fn from(reader: R<CTRL2_SPEC>) -> Self

Converts to this type from the input type.