[−][src]Type Definition esp32::rmt::rmt_ch4conf0_reg::W
type W = W<u32, RMT_CH4CONF0_REG>;
Writer for register RMT_CH4CONF0_REG
Methods
impl W
[src]
pub fn rmt_carrier_out_lv_ch4(&mut self) -> RMT_CARRIER_OUT_LV_CH4_W
[src]
Bit 29 - This bit is used to configure carrier wave's position for channel4.1'b1:add on low level 1'b0:add on high level.
pub fn rmt_carrier_en_ch4(&mut self) -> RMT_CARRIER_EN_CH4_W
[src]
Bit 28 - This is the carrier modulation enable control bit for channel4.
pub fn rmt_mem_size_ch4(&mut self) -> RMT_MEM_SIZE_CH4_W
[src]
Bits 24:27 - This register is used to configure the the amount of memory blocks allocated to channel4.
pub fn rmt_idle_thres_ch4(&mut self) -> RMT_IDLE_THRES_CH4_W
[src]
Bits 8:23 - In receive mode when the counter's value is bigger than reg_idle_thres_ch4 then the receive process is done.
pub fn rmt_div_cnt_ch4(&mut self) -> RMT_DIV_CNT_CH4_W
[src]
Bits 0:7 - This register is used to configure the frequency divider's factor in channel4.