Struct esp32_hal::pac::uart0::status::R

pub struct R(_);

Register STATUS reader

Implementations

impl R

pub fn rxfifo_cnt(&self) -> FieldReaderRaw<u8, u8>

Bits 0:7 - (rx_mem_cnt rxfifo_cnt) stores the byte num of valid datas in receiver’s fifo. rx_mem_cnt register stores the 3 most significant bits rxfifo_cnt stores the 8 least significant bits.

pub fn st_urx_out(&self) -> FieldReaderRaw<u8, u8>

Bits 8:11 - This register stores the value of receiver’s finite state machine. 0:RX_IDLE 1:RX_STRT 2:RX_DAT0 3:RX_DAT1 4:RX_DAT2 5:RX_DAT3 6:RX_DAT4 7:RX_DAT5 8:RX_DAT6 9:RX_DAT7 10:RX_PRTY 11:RX_STP1 12:RX_STP2 13:RX_DL1

pub fn dsrn(&self) -> BitReaderRaw<bool>

Bit 13 - This register stores the level value of the internal uart dsr signal.

pub fn ctsn(&self) -> BitReaderRaw<bool>

Bit 14 - This register stores the level value of the internal uart cts signal.

pub fn rxd(&self) -> BitReaderRaw<bool>

Bit 15 - This register stores the level value of the internal uart rxd signal.

pub fn txfifo_cnt(&self) -> FieldReaderRaw<u8, u8>

Bits 16:23 - (tx_mem_cnt txfifo_cnt) stores the byte num of valid datas in transmitter’s fifo.tx_mem_cnt stores the 3 most significant bits txfifo_cnt stores the 8 least significant bits.

pub fn st_utx_out(&self) -> FieldReaderRaw<u8, u8>

Bits 24:27 - This register stores the value of transmitter’s finite state machine. 0:TX_IDLE 1:TX_STRT 2:TX_DAT0 3:TX_DAT1 4:TX_DAT2 5:TX_DAT3 6:TX_DAT4 7:TX_DAT5 8:TX_DAT6 9:TX_DAT7 10:TX_PRTY 11:TX_STP1 12:TX_STP2 13:TX_DL0 14:TX_DL1

pub fn dtrn(&self) -> BitReaderRaw<bool>

Bit 29 - The register represent the level value of the internal uart dsr signal.

pub fn rtsn(&self) -> BitReaderRaw<bool>

Bit 30 - This register represent the level value of the internal uart cts signal.

pub fn txd(&self) -> BitReaderRaw<bool>

Bit 31 - This register represent the level value of the internal uart rxd signal.

Methods from Deref<Target = R<STATUS_SPEC>>

pub fn bits(&self) -> <REG as RegisterSpec>::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<STATUS_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<R as Deref>::Target

Dereferences the value.

impl From<R<STATUS_SPEC>> for R

fn from(reader: R<STATUS_SPEC>) -> R

Converts to this type from the input type.