Struct esp32_hal::pac::uart0::idle_conf::W

pub struct W(_);

Register IDLE_CONF writer

Implementations

impl W

pub fn rx_idle_thrhd(
    &mut self
) -> FieldWriterRaw<'_, u32, IDLE_CONF_SPEC, u16, u16, Unsafe, 10, 0>

Bits 0:9 - when receiver takes more time than this register value to receive a byte data. it will produce frame end signal for uhci to stop receiving data.

pub fn tx_idle_num(
    &mut self
) -> FieldWriterRaw<'_, u32, IDLE_CONF_SPEC, u16, u16, Unsafe, 10, 10>

Bits 10:19 - This register is used to configure the duration time between transfers.

pub fn tx_brk_num(
    &mut self
) -> FieldWriterRaw<'_, u32, IDLE_CONF_SPEC, u8, u8, Unsafe, 8, 20>

Bits 20:27 - This register is used to configure the num of 0 send after the process of sending data is done. it is active when txd_brk is set to 1.

pub unsafe fn bits(&mut self, bits: u32) -> &mut W

Writes raw bits to the register.

Methods from Deref<Target = W<IDLE_CONF_SPEC>>

pub unsafe fn bits(&mut self, bits: <REG as RegisterSpec>::Ux) -> &mut W<REG>

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<IDLE_CONF_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<W as Deref>::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut <W as Deref>::Target

Mutably dereferences the value.

impl From<W<IDLE_CONF_SPEC>> for W

fn from(writer: W<IDLE_CONF_SPEC>) -> W

Converts to this type from the input type.